Motion Zone Setup - Speco D8DS User Manual

SEQUENCE
DWELL TIME
SPOT CHANNEL

4-4-5. Motion Zone Setup

Select MOTION ZONE using the mouse or the remote control and select either PARTIAL ZONE or FULL
ZONE using the mouse control. The default value is FULL ZONE.
If FULL ZONE is selected, the motion zone grid screen is not displayed. Only set the level of sensitivity for
MOTION SENSITIVITY.
FULL ZONE: The motion sensor is active on the whole screen.
PARTIAL ZONE: The motion sensor is active in the set detection frame.
Select the motion detection position using the mouse or the remote control. Then left click on the mouse or
left click and drag the mouse pointer to select or deselect the area. Highlighted area indicates the partial
motion detection zone. Press the ESC button or right click on the mouse to return to the previous menu.
Set the dwell time for the spot channel display. (1-10sec)
Select a channel for spot monitoring using the mouse or the remote
control and press OK button.
Figure 4.4.5. Motion Zone Grid Screen
34