Alpine CDE-142E Owner's Manual page 29

 Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna, if
applicable.
Note
• This lead should be used only for controlling the vehicle's power
antenna. Do not use this lead to turn on an amplifier or a signal
processor, etc.
 Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your amplifier or
signal processor.
 Audio Interrupt In Lead (Pink/Black)
Not used.
 Not used
 Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle's fuse box or
another unused power source which provides (+) 12V only when the
ignition is turned on or in the accessory position.
 Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle's battery.
 Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle. Make sure
the connection is made to bare metal and is securely fastened using
the sheet metal screw provided.
 Right Front (+) Speaker Output Lead (Grey)
 Right Front (−) Speaker Output Lead (Grey/Black)
 Right Rear (−) Speaker Output Lead (Violet/Black)
 Right Rear (+) Speaker Output Lead (Violet)
 Left Rear (+) Speaker Output Lead (Green)
 Left Rear (−) Speaker Output Lead (Green/Black)
 Left Front (−) Speaker Output Lead (White/Black)
 Left Front (+) Speaker Output Lead (White)
 Antenna Receptacle
 Front Output RCA Connectors
RED is right and WHITE is left.
 Rear/Subwoofer Output RCA Connectors
RED is right and WHITE is left.
 Fuse Holder (10A)
 Power Supply Connector
 RCA Extension Cable (sold separately)
 Front AUX Input Terminal
This terminal allows for input of audio from an external device (such
as a portable player), using a commercially-available converter cable.
 USB Terminal
Connect this to a USB Memory or an iPod/iPhone (sold separately).
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the
car harness.
• Keep the battery power leads as far away from other leads as
possible.
• Connect the ground lead securely to a bare metal spot (remove
any paint, dirt or grease if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away
from the unit as possible. Your Alpine dealer carries various
noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention
measures so consult your dealer for further information.
30
-EN