Installation Location Requirements; Clearances - LG DLE1001W Owner's Manual

Installation location requirements

WARNING
you review this entire manual before installing and using your dryer. Detailed instructions concerning electrical
connections, gas connections, and exhaust requirements are provided on the following pages.
gas dryer must be exhausted to the outdoors.
See
at the end of an automatic cycle. This can result in longer drying times. The dryer must not be installed or stored in
an area where it will be exposed to water and/or weather. Check code requirements. Some codes limit, or do not
permit, installation of the dryer in garages, closets, mobile homes or
sleeping quarters. Contact your local building inspector.
NOTE
operate correctly if dryer is not level.

Clearances

1
21 / "
4
(54 cm)
50
(127.5 cm)
INSTALLATION SPACING FOR RECESSED AREA OR CLOSET INSTALLATION
The following spacing dimensions are recommended for this dryer. This dryer has been tested for spacing of
reasons:
installation and servicing.
and floor moldings.
NOTE
vibration from one to the other. If there is too much vibration, it could cause them to make noise or touch each
other causing paint damage and making even more noise.
14" max.*
(35.6 cm)
3
40 / "
16
(102 cm)
15
28 / "
16 5"**
(73.4 cm)
(12.7 cm)
1
/ "
4
INSTALLATION INSTRUCTIONS
appliance should also be considered.
No other fuel-burning appliance can be installed in the
same closet as a dryer.
(2.54 cm) (68.6 cm) (2.54 cm)
of the dryer to reduce noise transfer.
For closet installation, with a door, minimum
ventilation openings in the top and bottom of the
door are required. Louvered doors with equivalent
ventilation openings are acceptable.
considered.
It is important that
(7.6 cm)
Closet Door Vent
(7.6 cm)
Requirements
13