Operation; Switch The Device On; Switching Off The Device; Activating Power-Saving Mode - Fujitsu ESPRIMO X913 Operating Manual

Operation

Switch the device on

► Press the ON/OFF switch on the front of the device.
The power indicator glows and the device is started.

Switching off the device

► Shut down the operating system in a defined manner. In Windows: via the
Start menu and the Turn Off Computer function.
Device, Monitor,
► If the operating system does not automatically switch the device into energy-saving
mode or switch it off, press the ON/OFF switch until the device switches off.
Warning, this could lead to a loss of data!
If the device is switched off, the device consumes a minimum of energy.
The ON/OFF switch does not disconnect the device from the mains voltage. To
completely disconnect the mains voltage, remove the power plug from the power socket.

Activating power-saving mode

Due to customer requirements and requirements of the operating system, the "Wake-on-LAN"
(WoL) function is set by default. The WoL function increases the idle current slightly.
In order to meet the requirements of EU Directive "COMMISSION REGULATION
(EC) No 1275/2008 of 17 December 2008 implementing Directive 2005/32/EC", the
default WoL settings must be changed as follows:
► To start the BIOS Setup Utility after system boot, press function key
► In the Power sub-menu, select the Low Power Soft Off setting and switch it to enabled.
► To save the setting and exit the BIOS Setup Utility, press function key
After making this change, the system will achieve the lowest energy
saving mode during shut-down.
Fujitsu
Operation
F2 .
F4 .
31