Anti-Tip Bracket Installation - Frigidaire FFES3015LSH Installation Instructions Manual

Anti-Tip Bracket Installation
_To reduce the risk of tipping of the
range, the range must be secured to the floor by the
properly installed anti-tip bracket and screws packed with
the range. Failure to install the anti-tip bracket will allow
the range to tip over if excessive weight is placed on an
open door or if child climbs upon it. Serious injury might
result from spilled hot liquids or from the range itself.
If range is ever moved to a different location, the anti-tip
bracket must also be moved and installed with the range.
C. Level and position the rang_e - Slide range to
its final position. Insert the range leveling leg in the
anti-tip bracket. Visually verify if the anti-tip bracket is
engaged. Lower the range by adjusting the 4 leveling legs
alternatively until the range is level. Check if the range
is level by placing a spirit level on the oven rack. Take 2
readings with the spirit level placed diagonally; take a
reading in one direction and then in the other direction.
Level the range if necessary by adjusting the leveling legs.
Instructions are provided for installation in wood or
cement floor. When fastening to floor, be sure that screws
do not penetrate electrical wiring or plumbing.
A, Locate the Bracket Using the Template - Locate the
bracket position (right or left side) by placing the template
symmetrically to the center of the final range position.
Mark the location of the screw holes, shown on template.
Range side
Figure 13
Figure 11
B. Drill Pilot Holes and Fasten Bracket - Drill a 1/8"
pilot hole where screws are to be located. If bracket is to
be mounted to the wall, drill pilot hole at an approximate
20 ° downward angle. If bracket is to be mounted to
masonry or ceramic floors, drill a 3/16" pilot hole 1-3/4"
deep. The screws provided may be used in wood or
concrete material. Use a 5/16" nut-driver or flat head
screwdriver to secure the bracket in place.
FASTEN BRACKET
(WALL OR FLOOR MOUNTING)
Leveling leg
Wall mount
__
Floor Mount
\ \ ) / //_
Anti=Tip Bracket
Figure 12
Figure 14
i
Figure 15
10