Download Print this page
Frigidaire FTF2140ES1 Installation Instructions Manual
Frigidaire FTF2140ES1 Installation Instructions Manual

Frigidaire FTF2140ES1 Installation Instructions Manual

Full size tumble action washers
Hide thumbs Also See for FTF2140ES1:

Advertisement

Full Size Tumble
Action
Washers
Before
beginning
installation,
carefully
read these instructions.
This will simplify
the
instaffation
and ensure the washer is installed correctly and safely. Leave these instructions
near the washer after installation
for future reference.
NOTE: The electrical
service
to the washer
must conform
with
local codes and ordinances
and the latest
edition
of the National
Electrical
Code, ANSI/NFPA
70.
For your safety the information
in
this manual must be followed to minimize the risk
of fire or explosion or to prevent property damage,
personal injury or loss of life.
- Do not store or use gasoline or other flammable
vapors and liquid in the vicinity of this or any
other appliance.
- WHAT TO DO IF YOU SMELL GAS
. Do not try to light any appliance.
. Do not touch any eIectrica[ switch; do not
use any phone in your building.
. Clear the room, building
or area of all
occupants.
. immediately
call your gas supplier from a
neighbor's phone. Follow the gas suppliers
instructions.
. if you cannot reach your gas supplier, call
the fire department.
installation
and service must be performed
by a
qualified
installer,
service agency
or the gas
supplier.
Printed in U.S.A.
Contents
SUBJECT
PAGE
Preqnstallation Requirements
2
Electrical Requirements
2
Grounding Requirements
2
Water Supply Requirements
2
Drain Requirements
2
Roughqn Dimensions
3
Location Of Your Washer
4
Unpacking
4
Installation
4-6
Replacement Parts
6
P/N 134594900A (0509)

Advertisement

loading

Summary of Contents for Frigidaire FTF2140ES1

  • Page 1 Full Size Tumble Action Washers Before beginning installation, carefully read these instructions. This will simplify instaffation and ensure the washer is installed correctly and safely. Leave these instructions near the washer after installation for future reference. NOTE: The electrical service to the washer must conform with...
  • Page 2 absence of local codes, with tile National Electrical PRE-INSTALLATION REQUIREMENTS Codes, ANS!/NFPA 70 (latest edition). If in doubt, call a licensed electri(ian. DO NOTcut off or alter Tools Required for Installation: the grounding prong on the power supply cord. In 1.
  • Page 3 ROUGH-IN DIMENSION5 27 . 75 .......... _7o.5 _..24" (61) ....-1 ..Power' Cord 33.40 t ........... SIDE NOTE: For pedestM or undercounter instMladonL reference 5 WnstMladon" 2 7 _ ............... (6a.8) ........6,75 { 2:_ ,f_) (17.) 2 °...
  • Page 4 LOCATION OF YOUR WASHER DO NOT INSTALL YOUR WASHER: Cover the bolt holes with plugs located in the In an area exposed to dripping water or outside weather conditions. The ambient temperature should literature bag. never be below 60° F(!5.6 ° C) for proper washer Using the shipping posts, prop up the front of the (detergent breakdown) operation.
  • Page 5 INSTALLATION Leve//ng the Washer Excessive noise and vibration (an be prevented by properly leveling tile washer and tightening the leveling leg lock r/uts. 1 For free standinq installation and with tile washer in it's tir/al position, place a level on top ol the washer. Adjust the leveling legs so the HOSE TABS...
  • Page 6 Cable Tie REPLACEMENT PART5 If replacements parts are needed for your washer, contact the source where you purchased your washer, call 1o800-944o9044, or visit our website, www_frigidaire corn, for the Frigidaire Company Authorized Parts Distributor nearest you Cable Tie Destroy...

This manual is also suitable for:

Bltf2940es1Gltf2940es1