Download Print this page

Gas Conversion - Frigidaire FFGC2605LWA Installation Instructions Manual

Gas cooktop
Hide thumbs Also See for FFGC2605LWA:

Advertisement

Available languages

Available languages

5. LP/Propane
Gas Conversion
A. Pressure
Regulator
Conversion
IMPORTANT: Except for Puerto Rico 30" model PGP332L
all cooktops are shipped from the factory
set for use with Natural Gas.
Note: • Do not remove the Pressure Regulator.
If in doubt about the pressure at the manifold,
use a manometer. Tile inlet pressure on the
regulator must be at least 1 " W.C. higher than
the outlet pressure. Inlet pressure on the
regulator must never exceed 14" W.C.
1, Convert
the Pressure Regulator
from Natural
Gas to LP Gas (see figure
8)
A. Remove the cap from the pressure regulator.
B. Remove the plunger.
C. Turn the plunger upside down with the
enlarge end DOWN.
D. Replace the plunger inside the regulator. The
letters LP or !0" W.C. should be visible on the
exposed end of the plunger.
E. Replace the cap on the pressure regulator.
Plunger- Enlarged
_,X-J¢_ Cap
end DOWN for LP "_i_
Gas
Figure 8
LP Gas
2. Convert
the Pressure Regulator
from LP Gas
to NATURAL Gas (see figure
9)
A. Remove tile cap from tile pressure regulator.
B. Remove the plunger.
C. Turn the plunger upside down with the
enlarge end UP.
D. Replace the plunger inside the regulator. The
letters NAT or 4" W.C. should be visible on
the exposed end of the plunger.
E. Replace the cap on the pressure regulator.
B_
Plunger - Enlarged _¢_
Cap
end UP for Natural
8
Gas
Figure 9
Natural Gas
Burner
Valves
Conversion
(see figure
10 and 11)
Figure !0
1.
Remove valve knobs, top grates, burner pans
and lift cooktop to gain access to valves. Locate
valve hoods (orifices) on back side of valves.
2a. To convert burner valves from Natural
Gas
to LP Gas, turn valve hoods (orifices) down until
snug against tile mixer pin (approximately 2 72
turns). Do not overtighten.
2b. To convert
burner valves from LP Gas to
Natural
Gas, turn valve hoods (orifices) up until
it is away from tile mixer pin (approximately
2 _/2
turns).
3.
Apply gas to tile burner and adjust pilots and air
shutter on burner venturi tube to proper flame
(refer to pictures in "Burner Flame Adjustment"
section for comparison).
Pin
Natural Gas -_
_/- Hood
¥
/--LP Gas
Figure 11
7

Advertisement

loading