Advertisement
Available languages
Available languages
7. Connect
Electricity
to Gas
Cooktop
Electrical
Requirements
120 volt, 60 Hertz, properly grounded branch circuit
protected by a 15 amp circuit breaker or time delay fuse.
Do not use an extension
cord with this cooktop.
IMPORTANT Please read carefully.
For personal
safety,
this appliance
must
be properly
grounded.
The power cord of this appliance is equipped with a 3-
prong (grounding) plug which mates with a standard 3-
prong grounding wall receptacle (see Figure 8) to
minimize the possibility of electric shock hazard from the
appliance.
The wall receptacle and circuit should be checked by a
qualified electrician to make sure the receptacle is
properly grounded.
Preferred
Method
Grounding
type wall
receptacle
_Do not, under any"_+
_'__Uor_ Set, anc ;Syp_aU ts' :
the grounding
__
_
prong.
J
|_W
Power supply cord with
_
3-prong
ground
ng pug
Figure
10
Where a standard 2-prong wall receptacle is installed, it
is the personal responsibility and obligation of the
consumer to have it replaced by a properly grounded 3-
prong wall receptacle.
Do not,
under
any circumstances,
cut or remove
the
third
(ground)
prong
from
the power
cord.
Disconnect electrical supply cord from
wall receptacle before servicing cooktop.
8. Check
Operation
Refer to the Use and Care Guide packaged with the
cooktop for operating instructions and for care and
cleaning of your cooktop.
Do not touch the burners. They may be hot enough to
cause burns.
1.
Install Burner Caps
This cooktop is equipped with sealed burners as
shown (see Figure 11).
Burner Base--.
3urner Par
/
\
k
i
i
J
Gas Opening
A.
B.
C.
NOTE:
Electrode --/
Figure 11
Unpack burner bases, burner pans and burner
caps.
Place burner pans and burner base over each
gas opening tube.
Make sure the burner is properly aligned and
leveled. Place burner cap over each burner
base.
There are no burner adjustments
necessary
on
Advertisement
