Frigidaire FARE4044MW0 Installation Manual page 17

Yourdryerisdesigned s othedoorswingmaybereversed a t anytimewithoutadditional parts.Conversion is
accomplished bytransferring h inges anddoorstriketo theopposite sides ofthe cabinet.
1 Besureyouhave adequate s wingarea
before reversing door.
2 Youwill need a screw driverwitha #2 square
bit anda pairof pliers.
3 Protect f iatworksurface, suchastopof dryer
or floorneardryer, w itha softclothor towel.
4 Besuredryerisunplugged frompower s ource!
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source
before servicing could result in
........... personal inJu_ or even death: ............................................................
Tools needed:
Screwdriver with #2 Adjustable
square bit pliers
Open door and remove four plugs in the door opening
opposite the hinges. Retain all parts for use later,
unless otherwise noted. (Figure below)
Place door on a towel (front side down) to prevent
scratches to paint or window (if equipped). Remove
all four remaining long hinge screws on edge of door.
(Figure below)
Youmay need
a
plasticknifeto help pullout the plugs,
Be careful not to scratch the paint.
ii
o
"D" STAMPED ON
DOOR SIDE OF
HINGE INTERIOR
Begin removing the four short screws that attach the
hinge to the front panel. (Figure Above) Start by only
removing one screw per hinge. Then only loosen the
two remaining screws while firmly holding the door to
prevent damage to hinge, front panel or door. After the
remaining screws are loosened, continue to remove all.
Observe the "D" stamped on the interior of the hinge
on the door side. When reversed to the other side, this
"D" must be visible after the hinge is remounted.
DOOR EDGE
SCREWS (x 4)
DOOR HINGE
SCREWS (x 4)
4 Remove the four long screws from edge of door
opposite hinges. (Figure above)