Frigidaire FEB27T6CSA Installation Instructions Manual

Electric wall oven
Hide thumbs Also See for FEB27T6CSA:
Table of Contents

Advertisement

Available languages

Available languages

INSTALLATION
AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT:
SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE.
_t_,w,__:i_il_[el FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance.
Your new wall oven has been designed to fit a limited variety of cutout sizes to make the job of installing
easier. The first step of your installation should be to measure your current cutout dimensions and
compare them to the cutout dimensions chart below or next page for your model. You may find little or
no cabinet work will be necessary.
_!,W:I:t_11_[€ 1 Do not remove spacers (if equipped)
on the side walls and/or on the back of the built-in oven.
These spacers center the oven in the space provided.
The oven must be centered to prevent excess heat buildup
that may resu t n heat damage or f re.
DO NOT INSTALL A 24" WALL OVENS IN A BASE CABINET WITH A COUNTERTOP ABOVE IT.
NOTE: Dimension G is critical to the proper installation of the built-in oven.
If the oven decorative trim (ventilation)
does not
but against the cabinet, or if noise is heard on convection models, verify dimension G to assure it is according to the required
dimension.
NOTE: For a cutout height greater than H Min. dimension add
one 2" (5 cm) wide wood shim to each side of the opening under
the appliance side rails.
NOTE: Base must be capable of
supporting
150 pounds (68 kg).
** NOTE: Allow at least 19 3/8" (49.2
cm) clearance for door depth when it is
open.
* Suggested distance from
floor is 31 " (78.7 cm).
Minimum
required distance
is 18" (45.7 cm).
Except for 30" models,
minimum required distance
is 4 1/2" (11.4 cm).
**Door Open
(see note)
"%
"%
"%
Figure
1
24" AND 30" SINGLE OVENS
(Double
Ovens
see Figure 2)
1 1/2"
(38 cm)
Min
28 3/32 _
/
(71 4 cm)
H
31 °*
(78.7 cm
2'* (5.1 cm) Wide
Spacer if Needed
Hole for cable and
electrical iunction
box on
left side for 30" Wall
Ovens.
Hole for cable and
electrical
junction
box on right side for
24" Wall Ovens.
/
_3"
(76 cm)
Max
Electrical Junction
Box (Right Or left
side depending
of
model)
24" (61 cm) Wall Oven
23 7/8 (60.6)
30 3/4 (78.1)
21 11/16 (55.1)
25 3/8 (64.5)
30" (76.2 cm) Wall Oven
29 7/8 (75.9)
29 7/8 (75.9)
28 3/8 (72.1)
25 3/8 (64.5)
24" (61 cm) Walt Oven
22 (55.9)
22 1/4 (56.5)
23 1/2 (59.7)
28 1/8 (71.4)
30 1/8 (76.5)
24 (61) Min
30" (76.2 cm) Wall Oven
28 1/2 (72.4)
29 (73.7)
24 (61)
28 1/4 (71.8)
28 7/8 (73.3)
30 (76.2) Min
All dimensions
are in inches (cm).
Some models
are not available
in Canada.
P/N 318201510
(0208)
Rev. A
English - pages 1-8
Espa_ol - p_ginas 9-16
Fran_ais - pages 17-24

Advertisement

Table of Contents
loading

Summary of Contents for Frigidaire FEB27T6CSA

  • Page 1 INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. _t_,w,__:i_il_[el FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
  • Page 2 _I,'_V_'_H_ll_[el Do not remove spacers (if equipped) on the side wails and/or on the back of the built-in oven. These spacers center the oven in the space provided. The oven must be centered to prevent excess heat buildup that may result in heat damage or fire. I 1/2"...
  • Page 3: Important Safety Instructions

    Important Observe all governing codes and local ordinances Notes to the Installer A 3-wire or 4-wire single phase 120/208 or 120/240 Read all instructions contained in these installation Volt, 60 Hz AC only electrical supply is required on instructions before installing the wall oven. a separate circuit fused on both sides of the line Remove all packing material from the oven (time-delay fuse or circuit breaker is recommended).
  • Page 4: Adjusting Oven Height

    Wait at least three (3) hours after OVEN receiving this built-in oven before switching the power on to prevent possible damage to the built-in oven control at power on 3. Adjusting Oven Height A. Models with extension panel (some models only): Remove and lay aside the lower vent decorative trim that is taped to the outer side panel of the oven.
  • Page 5 If connecting to a 4-wire electrical Cable from Power Supply Black system (mobile homes), the appliance frame MUST Ground Wire _ Wires NOT be connected to the neutral wire of the 4-wire electrical system. Wires NOTE TO ELECTRICIAN: The armored cable leads Junction Box supplied with the appliance are CSA-recognized for Wire...
  • Page 6: Double Ovens

    30", Single and Double Ovens Cutout Dimensions _The wall oven can tip when the 28 1/2" (72.4 cm) Min.* door is open. The anti-tip brackets 29" (73.7 cm) Max.* supplied with the wall oven must be attached to ....the cabinet and the appliance to prevent tipping 28 1/16"...
  • Page 7 Side fillerpanels a renecessary to isolate t heunitfromadjoining cabinets. To reduce the risk of personal injury and tipping the wall oven, the wall oven must be secured to 36" Min. the cabinet(s) by (91.4 cm) properly installed anti=tip screws or brackets.
  • Page 8 Leveling Bake-After setting the oven to 350°F/177°C for baking, the Wall Oven the lower element in the oven should become red. Install an oven rack in the center of the upper oven (see Figure 11). Broil-When the oven is set to BROIL, the upper element Place a level on the rack.
  • Page 9 LA INSTALACION Y EL SERVICIO DEBE DE HACERLOS UN INSTALADOR CALIFICADO. IMPORTANTE: GUARDE ESTAS INSTRUCCIONES PARA USO DEL INSPECTOR ELI_CTRICO LOCAL. LEA Y GUARDE ESTAS INSTRUCCIONES PARA FUTURAS REFERENCIAS. PARA SU SEGURIDAD: No almacene ni utilice gasolina u otros vapores y liquidos inflamables en la proximidad de este o de cualquier otro artefacto.
  • Page 10 No quite los separadores (si los hay) de los muros laterales o/y de la parte posterior del horno emportado. Estos espaciadores centran el homo en el espacio provisto. El homo debe estar centrado para prevenir una concentracibn excesiva de calor que podria resultar en dafios pot el calor o un incendio. 11/2 '` I_._, (38 cm) /...
  • Page 11: Requisitos El Ctricos

    Cumpla con todos los cbdigos en vigor y todos los re- Notas importantes para el instalador glamentos locales. Lea todas las instrucciones contenidas en este manual 1. Para el suministro electrico solamente se necesita antes de instalar el horno. corriente con frecuencia de 60 Hz AC y fase 0nica de Saque todo el material...
  • Page 12: Del Horno

    PUERTA I_1_ Cuando utilice su horno empotrado pot la HORNO primera vez, espere por lo menos tres (3) horas antes de conectarlo al suministro el_ctrico. Los controles el_ctricos pueden set dahados al conectar el homo a la potencia electrica. 3. Ajustando la Altura del Horno A.
  • Page 13 Cabb de la fuente de alimentac6n Si esta conectado a un sistema el_ctrico de 4 alambres (casa movible), el armaz6n del eletrodomestico NO TIENE QUE estar conectado al alambre neutro del sistema electrico de 4 alambres. NOTA AL ELECTRICISTA: Los conductores de cable blindados provistos con este artefacto son aprobados por UL para la conexiOn al alambrado de casa de un calibre mayor.
  • Page 14 30", Modelos con un solo horno y de DimensJones det hueco horno doble 28 I/2" (724 cm) Min* El horno de pared puede inclinarse 29" (737 cm) Max* cuando la puerta esta abierta. Las fijaciones anti inclinacibn que vienen con el horno de pared 28 1/16"...
  • Page 15 Paneles Ilenadores laterales son necesarios para aislar el homo de los gabinetes adyacentes. La altura de los paneles debe dejar espacio sufidente para la instalaci6n de una estufa aprobada. Para reducir el riesgo de dafiospersonales y de que vuelque el homo a pared, el homo debe fljarse a 36"...
  • Page 16: Nota Importante

    6. Asegdrese de que el horno de pared est_ Hornear- Despues de poner el homo a 350°F/177°C para hornear, el elemento de la parte de abajo del a nivel homo se debe de ponerse rojo. Instale una rejilla al centro del homo superior (vea la...
  • Page 17 L'INSTALLATION ET L'ENTRETIEN DOIVENT _TRE EFFECTUI_S PAR UN INSTALLATEUR QUALIFII_. IMPORTANT : CONSERVEZ POUR L'INSPECTEUR D'I_LECTRICITI_ LOCAL. LISEZ ET CONSERVEZ CES INSTRUCTIONS POUR RI_FI_RENCES ULTI_RIEURES. POUR VOTRE SIeCURITIe: N'entreposez pas ou n'utilisez pas d'essence ou d'autres produits inflammables _ proximit_ de cet appareil ou de tout autre appareil _lectromenager. Votre nouveau four encastre...
  • Page 18 rl _:\,1_;i1_$-t_,_,1_;111 N'enlevez pas (s'il y en a) les entretoises sur les parois latdrales et/ou & I'arriere du four. Ces entretoises centrent le four dans I'espace fournL Le four dolt _tre centrd pour prdvenir une accumulation excessive de chaleur, pouvant causer un feu ou des dommages dr3 a un surchauffement. Trou pour le c_ble et bo_tede ** Porte ouverte (voir la note)
  • Page 19 Installateur Observez tous les r_glements et les codes Iocaux applicables. 1. Lisez toutes ces instructions avant de proc_der Un cable electrique _ 3 ou 4 fils de 120/240 ou 120/ l'installation de votre appareil. 208 Volt monophase, 60 Hz CA est requis sur un 2.
  • Page 20 II faut attendre au moins trois (3) heures PORTE EXT_RIEURE apres sa reception avant de mettre I'appareil sous tension pour eviter toute possibilite d'endommager la commande du four Iors de la mise sous tension. 3. R glage de la hauteur du four encastr A.
  • Page 21 C_ble d'alimentation lrl_'_ll Si la connexion a dte faite utilisant un syst_me dlectrique _ 4 fils (maison mobile), le chassis de I'appareil NE DOlT PAS _tre branche au fil neutre du c_ble _ 4 fils. leLECTRICIEN: Le c_ble gaine fourni avec cet appareil est homologue par I'ACNOR pour connexion...
  • Page 22 Fours 30" a cavit_ simple et a cavit_ Dimensions de decoupage double 28 1/2" (724 cm)Min* 29" (737 cm) Max* Le four encastr_ peut basculer quand la porte est ouverte. II faut ....le fixer _ I'armoire, les supports anti-bascules fournis avec le four encastre,...
  • Page 23 Des panneaux lat_raux s ont n_cessaires pourisoler I 'unit_ des armoires adjacentes. Pour pr_venir tout basculement du four encastre et des blessures, il faut fixer le four & I'armoire en 36" Min. installant (91.4 cm) correctement les supports ou les vis anti-bascules.
  • Page 24 6. Mise a niveau du four encastr_ Cuisson au four-Apres le reglage _ 177°C (350°F) pour la cuisson au four, I'element inferieur du four dolt Installez une grille clans le centre du four superieur devenir rouge. (voir Figure 11). Placez un niveau sur la grille. Prenez deux lectures Grillage-Lorsque GRILL est selectionne, I'element avec le niveau.

This manual is also suitable for:

Pleb27t8ccbFeb27t6cbaGleb27t8asc

Table of Contents