Table of Contents
Related Manuals for Monogram ZBD6920D00SS
Summary of Contents for Monogram ZBD6920D00SS
- Page 1 Instollotion Instructions Built-In Dishwoshers *Custom front panel models include c_kit that contains c_templote, hardware and panel installation instructions. Refer to the kit instructions when installing the custom panel. [31-30281 05-11 GE...
-
Page 2: Table Of Contents
While performing installations described in this booklet, covered under the GE Appliance Warranty. gloves, safetg glasses or goggles should be worn. • Completion Time - 1 to 3 Hours. For Monogram local service in your area, 1.800.444.1845. -
Page 3: Installation Preparation
Installation Preparation Countertop Bracket Kit PARTS SUPPLIED: • Two #8-18 x 5/8" Phillips special-head screws, to secure dishwasher to underside #8 Phillips Special-Head #10 Hex Head of countertop or sides of cabinets. #8 Phillips Pan head Top Mounting Screws 5/8" Long J-Box Screw Screws5/8"... -
Page 4: Advance Planning
Installation Preparation ADVANCE PLANNING • These dishwashers are designed for versatility, • These dishwashers may be installed beneath adaptable to virtually any installation. countertops of stone or other materials that will not accept screws. No trim kit required. • All models have a full-length door without the traditional access panel. -
Page 5: 23, Install Sound Upgrade Kit If Equipped
Installation Preparation PREPARE DRAIN PLUMBING Method 1--Air Gap with Waste Tee or Disposer Drain Requirements • Drain hose must not exceed 10 feet in length. • A high drain loop or air gap is required. See below. Drain Method The type of drain installation depends on the following: •... - Page 6 Installation Preparation PREPARE ELECTRICAL WIRING Alternate Receptacle FOR PERSONALSAFETY:Remove house fuse or open circuit breaker before beginning installation. Do not use an extension cord WARNING or adapter plug with this appliance. Electrical Requirements 5" from • This appliance must be supplied with 120V, 60 Hz. and Cabinet connected to an individual properly grounded branch circuit, protected by a 15- or 20-ampere circuit breaker...
- Page 7 Installation Instructions PREPARE HOT WATER SUPPLY STEP 1 I LOCATE INSTALLATION ITEMS • Locate the items in the installation package and set Hot Water Line aside for use in the listed steps. • The line may enter from either side, rear or floor within •...
-
Page 8: Step 4, Remove Wood Base, Install Leveling Legs
Installation Instructions STEP 3 CHECK DOOR BALANCE STEP 4 I REMOVE WOOD BASE, INSTALL LEVELING LEGS • With dishwasher on the wood skid, check the door balance by opening and closing the door. IMPORTANT-Do not kick off wood base! • If the door drops when released,increasethe spring tension. Damage will occur. -
Page 9: Step 9, Position Water Line And Housing Wiring
If a longer hose is needed, a 120" Front of Dishwasher long hose (10 feet), may be purchased from an authorized GE appliance dealer. The 10' long hose is part number GPFIOL Tip for leak-free Bracket connections: 90 ° EIbow_ •... -
Page 10: Step 11, Insert Drain Hose Through Cabinet
Installation Instructions STEP 11 INSERT DRAIN HOSE STEP 12 INSTALLCOUNTERTOPBRACKETS THROUGH CABINET (c_nt) • Position dishwasher in front of cabinet opening. Insert IMPORTANT- The brockets con be mounted drain hose into the hole in cabinet side. If a power cord is in the inner-set or outer-set hole locations. -
Page 11: Step 15 Level Dishwasher
Installation Instructions STEP 14 SLIDE DISHWASHER INTO STEP 15 LEVEL DISHWASHER FINAL POSITION (cont.) IM PO RTANT - Dishwasher must belevel for • Front of door panel should be flush with face of cabinet. proper dish rack operation and wash performance. •... -
Page 12: Step 16, Secure Dishwasher
Installation Instructions STEP 16 SECURE DISHWASHER TO STEP 17 CONNECT WATER SUPPLY COUNTERTOP OR CABINET Connect water supply line to 90 ° elbow. • Slide compression nut, then ferrule over end of In this step you will Co unt e rto p_--_""--->d_-_._ water line. - Page 13 Installation Instructions STEP 18 CONNECT DRAIN LINE DRAIN LINE INSTALLATION The molded end of the drain hose will fit 5/8" through • Connect drain line to air gap, waste tee or disposer 1" diameter inlet ports on the air gap, waste tee or using the previously determined method.
- Page 14 Installation Instructions STEP 19 CONNECT POWER SUPPLY STEP 20 PRETEST CHECK LIST Skip this step if dishwasher is equipped with Review this list after installing your dishwasher power cord. to avoid charges for a service call that is not covered by your warranty.
- Page 15 Installation Instructions/Custom Panel Dimensions STEP 21 DISHWASHER WET TEST STEP 23 INSTALLSOUND UPGRADEKIT IF EQUIPPED • Turn on power supply (or plug power cord into outlet, if equipped). Skip this step if your model does not have the Sound • Start the unit to check for leaks. Upgrade Kit.
- Page 16 For Honogrom _ Iocol service in your oreo, coil 1.800.444.1845. NOTE: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice. GE AppliGnces & Lighting Appliances General Electric Company Louisville, KY/40225...