Advertisement
lnsta mation
Instructions
Minimum
CUearance
Other
Than
AUcove or CUoset Installation
Minimum clearance to combustible
surfaces and for air opening are: 0 in. clearance both sides and 1 hr. rear. Consideration
must be given to provide adequate
clearance ]br proper operation and service.
[] PREPARING
FOR INSTALLATION
OF NEW
DRYER
CSA(AGA) A PPROVED
NEW FLEXIBLE GAS
LINE CONNECTOR
GAS
INLET
PIPE
EXTERNAL
DUCT
OPENING
DUCT
TAPE
4"METAL DUCT
DUCT
TAPE
TIP: Install your dryer before installing
your washer.
This will allow better
access when installing
dryer exhaust.
DISCONNECTING
GAS
DISCONNECT
ANDDISCARD O LD
FLEXIBLE GAS CONNECTOR
ANDOLDDUCTING M ATERIAL,
TURN GAS
SHUT-OFF
VALVE T OTHE
OFF POSITION,
WARNING-
NEVER REUSE OLD
FLEXIBLE CONNECTORS.
The use of old flexible connectors
can cause leaks and
personal injury. Ahvays use new flexible connectors when
installing gas appliances.
REMOVING
LINT FROM
WALL
EXHAUST
OPENING
WALL
/
INTERNALDUCT
CHECKTHATEXHAUST
OPENING
OPENS
ANDCLOSESFREELY,
TILT THE DRYER SIDEWAYS
AND REMOVE THE FOAM
SHIPPING
PADS B Y
PULLING
ATTHE SIDES
AND BREAKING
THEM
AWAY F ROM THE DRYER
LEGS, BE SURE TO
REMOVE
ALL OF THE
FOAM PIECESAROUND
THE LEGS,
[] GAS REQUIREMENTS
,_
WARNING
. Installation umst conlbrm to local codes and ordinances,
or in their absence, the NATIONAL
FUEL GAS CODE,
ANSI Z223.
° This gas dryer is equipped with a Valve & Burner Assem-
bly fbr use only with natural gas. Using conversion
kit
WE25X0217,
your local service organization
can convert
this dryer for use with propane
(LP) gas. ALL CONVER-
SIONS MUST BE MADE BY PROPERLY
TRAINED
AND QUALIFIED
PERSONNEL
AND IN AC-
CORDANCE
WITH LOCAL CODES
AND ORDI-
NANCE RE©_HREMENTS.
" The dryer nmst be disconnected
fl*om the gas supply
piping system during any pressure testing of that system
at a test pressure in excess of 0,5 PSI (3A KPa).
" The dryer nmst be isolated from the gas supply piping
system by closing the equipment
shut-offvalve
during
any pressure testing of the gas supply piping of test
pressure equal to or less than 0.5 PSI (3.4KPa).
DRYER GAS SUPPLY CONNECTION
2_q518,, _ 318" NPT MALE THREAD
GAS SUPPLY
NOTE: Add tovertical dimension
thedistance between cabinet
bottom tofloor,
GAS SUPPLY
" A 1/8-in. National Pipe %per thread plugged rapping, ac-
cessible %r test gauge connection,
nmst be installed imme-
diately upstream
of the gas supply connection
to the dryer.
Contact your local gas utility should you have questions on
the installation of the plugged tapping.
" Supply line is to be 1/2-in. rigid pipe and equipped with an
accessible shut-offwithin
l; R. of; and in the same room
with, the dryer.
, Use pipe thread sealer compound
appropriate
for natural
or LP gas or use Teflon tape.
" Connect flexible metal connector
to dryer and gas supply.
2
Advertisement
