Table of Contents
Related Manuals for PowerBass AEQ-4XOA
Summary of Contents for PowerBass AEQ-4XOA
-
Page 1: Owners Manual
AEQ-4XOA AUTOSOUND EQUALIZER/ PREAMP Owners Manual Please read through this manual to familiarize yourself with your new equalizer. Should your PowerBass equalizer ever require service, you will need to have the original dated receipt. - Page 2 This installation manual contains valuable information on how to get the most out of your new PowerBass AEQ-4XOA Equalizer. Virtually any car stereo system will benefit from the addition of this unique and versatile product. To learn more about PowerBass Autosound, please visit us on the World Wide Web at http://www.powerbassusa.com...
- Page 3 INSTALLATION EXPERIENCE Installation of your PowerBass mobile equalizer requires detailed knowledge of electronics wiring and prop- er installation skills. We strongly recommend installation by an authorized PowerBass dealer. This Owners Manual only provides general installation and operation instructions. If you have any reservations about your installation skills, please contact your local PowerBass dealer for assistance.
-
Page 4: Control Panel Layout
CONTROL PANEL LAYOUT 1. SUB VOL Control The Subwoofer Volume control independently adjusts the output level of the woofer to a level you enjoy (requires use of a dedicated woofer or bass amplifier connected to the rear RCA style inputs). 2. -
Page 5: Installation Precautions
• If possible, use tubing through grommets. MOUNTING THE EQUALIZER There are two basic mounting options for your PowerBass equalizer. One is to mount the unit under the dash with the supplied brackets as shown below: 3.0 Ø WASHER 3.0 Ø SPRING WASHER M 3.0 X 10 MACHINE... -
Page 6: Rca Interconnects
Choose the correct length and style of RCA interconnects for your needs (not included). Run all of the RCA cables from the amplifiers to the location of the PowerBass AEQ-4XOA. Make sure all the RCA cables are run on the opposite side of the vehicle from where you ran the power cables to the amplifiers. -
Page 7: Wiring Configurations
Connect the Radio/CD source unit to the Radio Input jacks. Make sure the Source input selector switch on the AEQ-4XOA front panel is in the correct position. Likewise, if only one set of RCA cables are run to your amplifier(s), make sure the Fader control is turned to the direction that gives you output to the jacks being used (clockwise for rear, counter-clockwise for front). - Page 8 Using FRONT and REAR Outputs When used in systems with separate amplifier channels for the front and rear speakers, run two sets of RCA cables from the AEQ-4XOA to the amplifiers. The following wiring configuration will allow for the use of the built-in fader: Using FRONT, REAR &...
-
Page 9: Equalization Adjustment
There are no strict rules to adhere to when setting the main equalizer controls. Common sense says to use your PowerBass EQ to make your system sound its best. However, don’t try to push your system too hard by overdriving the amplifiers and speakers resulting in damage to some of the components. -
Page 10: Troubleshooting Tips
(Due to continuing improvement, features and specifications are subject to change without notice) This manual is the exclusive property of PowerBass USA, Inc. Any reproduction of this manual, or use other than its intentions is strictly prohibited without the express consent of PowerBass USA, Inc. ©Copyright 2013 PowerBass USA, Inc. - Page 11 Some states do not allow limitations on the length of an implied warranty, so this limitation may not apply. No person is authorized to assume for PowerBass any other liability in connection with the sale of this product.
- Page 12 PowerBass Autosound – A division of PowerBass USA, Inc. 2133 S. Green Privado, Ontario, CA 91761 Tel. (909) 923-3868 – Fax (909) 923-8048 www.powerbassusa.com...