Troubleshooting Guide - Haier HPIM35W User Manual

English

Troubleshooting Guide

Problem
The compressor
makes a buzzing
noise when the
machine is on.
The LCD display
shows "POUR".
The LCD display
shows "FULL"
There is no display
on the LCD screen.
The ice cubes are
fusing together.
Water is not freezing
during the normal
ice-making cycle.
9
Possible Causes
The voltage is lower than
required. This unit requires a
minimum of 120 volts.
There is no water in the water
storage tank or the water
level is too low.
The filter is blocked.
There is too much ice in the
ice storage basket.
The temperature is too low.
The fuse is blown.
The ice-making time is too
long.
The water temperature in the
inner liner is too low.
The refrigerant is leaking.
There is a block in the refrig-
erating system.
Solution
Turn off the icemaker. Make sure the voltage is
120v and restart.
Fill the water storage tank with water and
restart the unit.
Clean the filter with a soft, flexible toothbrush.
Remove some ice from the ice storage basket.
Place the icemaker in a warmer place.
Replace the fuse.
Stop the machine and reset the ice-making
time. Start the machine after the ice block
melts.
Replace the water in the inner liner. The sug-
gested water temperature is 44.6˚ to 77˚F.
Contact an authorized service center.