GE PGP953 Installation Instructions Manual page 13

Installation Instructions
MAKING THE LP CONVERSION (CONT.)
[_ CHANGE COOKTOP BURNER
ORIFICES
FA] Remove the grates, burner caps, and burner
heads.
r_ using a 7mm nut driver, remove the burner
orifices. These may be accessed through the
burner holes in the cooktop.
Inner /.,_,(_ /f¢_ Burner
burner cop
Burner ,S_ Outer OR \_ cop
bose -__'_ burner _Burner
cap Burner head
Electrode Burner base
Orifice spuds located J/ Orifice spud located Electrode
through these openings through this opening
Tri-Ring Burner
_ etainer
Ring
NOTE: On all burners, the
orifices have a spring-loaded
retaining ring around the hex
head to hold the orifice in the
nut driver during installation
and removal. A slight amount
of force is required to push the
nut driver down over the ring.
Fc] Locate the LP/Propane orifices shipped inside
the literature package. They will have a digit
number and the letter "L" on the side.
(IMPORTANT: Save the orifices removed from
the appliance for future use.)
Each orifice will show a series of engraved
marks, (I, II, IV or V), located on the top.
These marks denote the location of each orifice to the
cooktop burner.
For PGP953 Models
For PGP959 & CGP350 Models
See instructions
for center burner
r_ CHANGE COOKTOP BURNER
ORIFICES (CONT.}
CENTER BURNER
15,000 BTU/hr Extra Large Burner (PGP953 Models)
Extended spud for center
extra large burner
Burner
Cap
Set Screw
I
7,1 ,-1
_,_ Choke
I
I
Burner
Head
Extended
Spud
Base
Orifice spud located
through this opening
13