Table of Contents
Advertisement
Operation
4. If starting after an empty hopper, turn
Feed Adjuster to "TEST" (for one 60
second cycle). This will purge pellets into
the auger tube and also allow you to check
the motors for operation. NOTE: The auger
motor will not operate with any of the
doors open.
5. Turn Feed Adjuster to #4.
If this is your first fire or you are trying
different pellets, set the feed adjuster to #4,
This is a conservative number and will prob-
ably need to be increased if maximum BTU
output is desired. After you know a feed rate
setting that works well for your application,
use that setting.
6. Flip the Igniter Switch up into the "AUTO"
position.
7. Turn the MAX. TEMP. Dial on the
control board to the desired temperature. This
setting must always be higher then the MIN.
TEMP. setting.
WARNING: HOT WHILE IN OPERATION.
KEEP CHILDREN, CLOTHING, AND
FURNITURE AWAY. CONTACT MAY CAUSE
SKIN BURNS.
25
Advertisement
Table of Contents
