Serial Plate Information - Kenmore 79097602301 Installation Instructions Manual

C. Level and position the ranc_ = Slide range to its
flnat position, Insert the range leveling teg in the anti-
tip bracket. Visually verify if the anti-tip bracket is
engaged. Lower the range by adjusting the 4 leveling
legs alternatively until the range is level. Check if the
range is level by placing a spirit level on the oven
rack. Take 2 readings with the spirit level placed
diagonally; take a reading in one direction and then
in the other direction. Level the range if necessary by
adjusting the leveling legs.
Range _
Leveling.
)_'bl i _I
LeQ _ _--- Anti-Tip
___ Bracket
To check if the anti-tip bracket is installed
properly, use both arms and grasp the rear edge
of range back. Carefully attempt to tilt range
forward. When properly installed, the range
should not tilt forward.
Range side
Figure 3
4. Serial Plate Information
The serial plate
is located as
shown. See the
serial plate for
the following
information:
A. Model, lot and
serial number of
range.
B. Kilowatt
rating (power
requirements).
C. Voltage ratings.
Figure 4
Leg
Leveler
Figure 5
Figure 6