Table of Contents
Advertisement
DVG-2016S/2032S User's Manual
NOTE: Out-of-Band DTMF transport method may vary with different VoIP networks, please
contact your VoIP provider for their preferred method.
Payload Type: payload type of RFC2833.
Volume: Defines the volume of RFC2833.
SIP_INFO: This is an alternative for DTMF event over IP. When enabled, DTMF is relayed over SIP
signaling path using SIP NOTIFY messages.
Enable Hook Flash Event: Auto, RFC2833, or SIP info can be selected for the signaling method of
Hook Flash event.
Disable: It is to disable Hook Flash Event.
Auto: It is used to send Hook Flash Event followed the type of Out-of-Band DTMF. (i.e. Hook Flash
Event is send by RFC 2833 if RFC 2833 is selected.)
SIP_INFO: It is to send Hook Flash Event by SIP INFO.
RFC 2833: It is to send Hook Flash Event by RFC 2833.
Enable Non-SIP Inbox Call: This feature allows user to make local calls. Local Call here means the
call does not go through the Internet and the dialed number is the extension of other line. You can
un-tick it to configure as all calls go through the Internet.
Line Settings
Listening Volume: Adjusts the earpiece or speaker volume.
Speaking Volume: Adjusts the microphone volume.
Tone Volume: Adds a new option to make tone volume adjustable. This setting will be applied to all
tones generated by the gateway including dial tone and busy tone.
Min. FXS Hook Flash Time: It is to set the minimum flash time for FXS detecting.
Flash Time: Used to adjust the detection period for flash signals from a phone set connected to an
FXS port. For example, if pressing the HOLD key sometimes disconnects a call, increasing the "Flash
Time" should fix this issue.
Enable Polarity Reversal: As a remote site answers calls from this extension the FXS port will
reverse polarity.
FXS Chip Option 1: It is to avoid mis-detecting the loop state of a subscriber line or PBX user loop by
FXS interface. In some places, the voltage of off-hook makes it mis-detect the idle state and the active
state by FXS interface. Untick this variable if it mis-detects the state by FXS interface in your place.
FXS Current: It is used to set FXS output current configuration.
D-Link Systems, Inc.
Advanced Options
29
Advertisement
Table of Contents
