Section 1 - Introduction
shimmed at the factory to provide a flat mounting surface that is parallel to the CCD. Under
normal use, it should not be removed. The rear cover has ventilation slots for air circulation and
also holds the water inlet and outlet connectors. Two clear plastic tubes connect the water inlet
and outlet fittings on the rear cover to the heat exchanger inside the back of the main body. There
is sufficient tubing to allow the rear cover to be opened to attach the camera handles or to change
the fuse located inside the rear of the main body.
1.1.4. Connections
For convenience in routing the various cables and connections to the camera, all of the connectors
required for power, communication, accessories and water circulation are located together on one
side of the camera body.
Each of the connections on the bottom of the camera is shown below with a brief explanation of its
function.
Page 10