Behringer ULTRABASS BXD3000H Quick Start Manual page 8

14
ULTRABASS BXD3000H
ULTRABASS BXD3000H Controls
(2) (3) (5) (6) (7)
(4)
(16)
(8) (10) (12) (14) (15)
(9) (11) (13)
(17) (20) (19)
(18) (21) (22)
15
Quick Start Guide
Step 2: Controls
(EN)
(1)
(1) The POWER switch turns the amplifier on. (13) Push this ON button to activate the ULTRABASS
function. The LED in the button will light up to
(2) Connect your bass guitar to the INPUT jack
indicate ULTRABASS is on. You can also control
using a ¼" mono plug (unbalanced).
this effect with the included footswitch.
(3) The GAIN 1 knob adjusts the input gain for
(14) Use the MASTER control to set the
channel 1.
overall volume.
(4) The CH 2 button switches between channel 1
(15) The PHONES jack is for connecting a
and channel 2. This can also be done using the
pair of headphones.
included footswitch.
(16) Power is supplied via the included
(5) The GAIN 2 knob adjusts the input gain for
IEC connector.
channel 2. As you turn the knob clockwise,
the distortion effect is continuously (17) Use the balanced DIRECT OUTPUT (XLR) to
blended in. route the audio signal from your BXD3000H
to the input on a mixing console.
(6) The SHAPE knob adjusts which frequencies are
scooped out of your bass tone. It only affects (18) Connect your BXD3000H to an external
channel 2. speaker using a speaker cable connected to
the SPEAKER OUTPUT jack.
(7) The LEVEL knob adjusts the volume of channel
2. Use this control to balance the volume (19) Connect the SEND jack to the input on
between channels 1 and 2. your effects device. Connect the output on
the effects device to the RETURN jack on
(8) The FBQ EQUALIZER has 7 slide controls,
the BXD3000H.
one for each frequency band. The maximum
boost/cut is 12 dB. (20) The CD IN jacks (RCA) allow you to connect an
external stereo signal. For example, you can
(9) The FBQ switch activates the FBQ spectrum
play along with music from a CD or MP3 player.
analyzer. The control LEDs, normally identical
when FBQ is off, now show the energy content (21) Send your signal (before the power
of each frequency band with a corresponding amp stage) via the LINE OUT jack with a
degree of brightness. The equalizer is always ¼" mono cable (unbalanced).
active regardless of the FBQ function.
(22) Connect the included footswitch to the
(10) The COMPRESSOR knob controls the FOOTSW(ITCH) jack to switch between
compression intensity. channels and activate/deactivate the
ULTRABASS function.
(11) Push this ON button to activate the compressor
for both channels. The LED in the button will
light up to indicate the compressor is on.
(12) The ULTRABASS control allows you to add
ultra-low frequencies one octave below your
bass signal. The ULTRABASS effect is available
for both channels.