Cub Cadet TANK SZ 54 Operator's Manual page 14

Steering Wheel
1. Remove the hardware for attaching the steering wheel
from beneath the steering wheel cap. Carefully pry off the
steering wheel cover to remove the hardware.
2. With the wheels of the machine pointing straight forward,
place the steering wheel over the steering shaft.
3. Place the belleville washer over the steering wheel and
secure with the hex lock screw. See Figure 3-9.
4. Place the steering wheel cover over the center of the steering
wheel and push downward until it "clicks" into place.
Proper steering column and seat adjustment will result in the
following (to adjust the seat see below):
In the neutral position with hands on the steering wheel,
• Operator's upper arms should be relaxed and
approximately vertical.
• Operator's forearms should be approximately
horizontal.
• Operator's back should stay in contact with the seat
back.
• Steering column should not contact operator's legs.
Check the results of any adjustments to the conditions described
above. Repeat any adjustment procedures as required until all
conditions are met.
14 S 3— A
ection SSembly
Steering
Wheel
Cover
Hex Lock
Screw
Belleville Washer
Figure 3-9
& S -U
et p
Installing the Seat
1. Remove the two flange lock nuts, washers and shoulder
bolts from the seat bracket. See Figure 3-10.
Figure 3-10
2. Place the seat into position and secure the seat into place with
the previously removed hardware as shown in Figure 3-10.
3. Remove the shoulder screw and flange lock nut from the
the support cable and install the support cable with the
previously removed hardware. See Figure 3-11.
Figure 3-11