Cub Cadet TANK L 48 Operator's Manual page 14

To adjust the height of the drive control levers:
1. Remove the flange lock nuts that secure the carriage bolts
in the drive control levers. See Figure 3-8.
Flange Lock Nuts
2. Remove the carriage bolts from the drive control levers and
reposition to the second set of holes in the mounting block.
3. Reinstall the carriage bolts and flange lock nuts, and
tighten to 28-34 ft-lbs.
4. The same adjustments should be made to both sides of the
mower.
To adjust the front-to-rear angle of the drive control levers:
1. Remove the carriage bolt and flange lock nut from the slot
of one of the drive control levers.
2. Lift and swing that control lever upward until the slotted
hole in the lever bracket aligns with one of the holes in the
pivot bracket. See Figure 3-9.
14 S 2— A
ection SSembly
Carriage
Bolts
Figure 3-8
Figure 3-9
& S -U
et p
3. From the inside insert the carriage boltthrough the control
lever slot and the hole of the pivot bracket. Secure with the
flange lock nut. See Figure 3-9.
4. Note the relative position of the control lever to the pivot
bracket, then repeat the previous steps to reposition the
other control lever in approximately the same position.
5. Refer to "Adjusting the Drive Control Levers" in the
Maintenance & Adjustments for instructions on the final
adjustment of the levers.
Installing the Seat
1. Remove the two flange lock nuts and shoulder bolts from
the seat bracket. See Figure 3-10.
Figure 3-10
2. Place the seat into position and secure the seat into place with
the previously removed hardware as shown in Figure 3-10.
3. Remove the shoulder screw and flange lock nut from the
the support cable and install the support cable with the
previously removed hardware. See Figure 3-11.
Figure 3-11