Snmp; Administration; Ip Settings - Tripp Lite B092-016 Owner's Manual

Chapter 14: Command Line Configuration

14.1.15 SNMP

To set-up the SNMP agent on the device:
# config -s config.system.snmp.protocol=[ UDP | TCP ]
# config -s config.system.snmp.trapport='port number' (default is 162)
# config -s config.system.snmp.address='NMS IP network address'
# config -s config.system.snmp.commnity='community name' (v1 and v2c only)
# config -s config.system.snmp.engineid='ID' (v3 only)
# config -s config.system.snmp.username='username' (v3 only)
# config -s config.system.snmp.password='password' (v3 only)
# config -s config.system.snmp.version=[ 1 | 2c | 3 ]
The following command will synchronize the live system with the new configuration:
# config -a

14.1.16 Administration

To change the administration settings to:
System Name
System Password (root account)
Description
# config -s config.system.name=og.mydomain.com
# config -P config.system.password
# config -s "config.system.location=Device in office 2"
NOTE: The -P parameter will prompt the user for a password, and encrypt it. In fact, the value of any config element can
be encrypted using the -P parameter, but only encrypted user passwords and system passwords are supported. If any other
element value were to be encrypted, the value will become inaccessible and will have to be re-set.
The following command will synchronize the live system with the new configuration:
# config –a

14.1.17 IP settings

To configure the primary network interface with static settings:
IP address 192.168.0.23
Netmask 255.255.255.0
Default gateway 192.168.0.1
DNS server 1 192.168.0.1
DNS server 2 192.168.0.2
# config -s config.interfaces.wan.address=192.168.0.23
# config -s config.interfaces.wan.netmask=255.255.255.0
# config -s config.interfaces.wan.gateway=192.168.0.1
# config -s config.interfaces.wan.dns1=192.168.0.1
# config -s config.interfaces.wan.dns2=192.168.0.2
# config -s config.interfaces.wan.mode=static
# config -s config.interfaces.wan.media=[ Auto | 100baseTx-FD | 100baseTx-HD | 10baseT-HD ] 10baseT-FD
To enable bridging between all interfaces:
# config -s config.system.bridge.enabled=on
To enable IPv6 for all interfaces
# config -s config.system.ipv6.enabled=on
To configure the management lan interface, use the same commands as above but replace:
config.interfaces.wan, with config.interfaces.lan
og.mydomain.com
secret
Device in office 2
(will prompt user for a password)
195