Weslo Pursuit 616s User Manual page 7

5. Attach the Handlebar (4) to the Handlebar Post (2)
with two M10 x 19mm Button Head Screws (25) and
two M10 Split Washers (26).
6. Insert the Seat Post (3) into the Frame (1). Press
the Seat Post Shield (30) down onto the Frame.
Align one of the holes in the Seat Post (3) with the
hole in the Frame (1). Turn the Seat Pin (14) as
shown and insert it fully into the Frame and the Seat
Post. Make sure to insert the Seat Pin through
one of the holes in the Seat Post; do not insert
the Seat Pin under the Seat Post.
Attach the Seat (16) to the Seat Post (3) with three
M8 Nylon Locknuts (24) and three M8 Split Washers
(41). Note: The Nylon Locknuts and Split Washers
may be pre-attached to the bottom of the Seat.
7. Identify the Left Pedal (45) (there is an ÒLÓ on the
Left Pedal for identification). Using an adjustable
wrench, tighten the Left Pedal counterclockwise into
the left arm of the Crank (29). Tighten the Right
Pedal (not shown) clockwise into the right arm of
the Crank. Tighten both Pedals as fully as possi-
ble. Important: After using the exercise cycle for
one week, retighten the Pedals. For best perfor-
mance, the Pedals must be kept properly tight-
ened.
Adjust the Left Pedal Strap (34) to the desired posi-
tion. Press the Left Pedal Strap onto the adjustment
tab on the Left Pedal (39). Adjust the Right Pedal
Strap (not shown) in the same way.
5
2
6
41
24
30
1
7
29
34
45
Tab
7
4
25
26
16
41
24
3
14