Optimum Picture Quality And Afterimage - Samsung PE40C Manual

Appendix
Optimum Picture Quality and Afterimage Burn-in Prevention
Optimum Picture Quality
To enjoy the optimum picture quality, go to Control Panel on your PC and adjust the resolution and

refresh rate as follows. The picture quality of TFT-LEDs may degrade if the optimum resolution is not
selected.
Resolution: 1920 X 1080

Vertical frequency (refresh rate): 56 ~ 75 Hz

Due to the nature of the manufacturing of this product, approximately 1 pixel per million (1ppm) may

be brighter or darker on the LED panel. This does not affect product performance.
The number of sub-pixels by LED panel type: PE40C, PE46C, PE55C: 6,220,800

Run "Auto

adjustment, adjust
Leaving the screen fixed on a stationary image for an extended period of time may cause afterimage

burn-in or defective pixels.
Activate power-saving mode or a dynamic screen saver if you will not be using the product for

an extended period of time.
Unlike CDT monitors, TFT-LED monitors (due to the nature of the panel) can be set to only one

resolution to obtain the optimum picture quality. Therefore, setting a resolution other than the
specified resolution may degrade the picture quality. To avoid this, it is recommended that you select
the optimum resolution specified for your monitor.
Adjustment" to improve the picture quality. If noise is still found even after auto
Coarse or Fine.
291
Appendix