AXIS M1054 Network Camera
Hardware overview
Hardware overview
1
2
1
Lens with Status LED indicator
2
Microphone
3
Light (white illumination LED)
4
PIR sensor
5
Speaker
6
Network connector (RJ-45)
7
Lock ring
8
Part number (P/N) & Serial number (S/N)
9
Power connector
10 I/O terminal connector
11 Control button
12 Power LED indicator
13 Network LED indicator
14 Wireless LED indicator (activated on wireless models only)
Connectors
Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet (PoE).
Caution
Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded
network cable (STP) may be appropriate or required. Any network cables that are routed in outdoor environments or similar
shall be shielded (STP) and intended for their specific use. Make sure that the network switch is properly grounded. See
Electromagnetic Compatibility (EMC) for regulatory requirements.
Control button - The control button is used for:
•
Connecting to an AXIS Video Hosting System service. See page 41. To connect, press and hold the button for about
1 second until the Status LED flashes green.
•
Connecting to AXIS Internet Dynamic DNS Service. See page 41. To connect, press and hold the button for
about 3 seconds.
5
3
4
6
7
8
5
9
10
1 1
12
13
14