Install the hard drive.
2.
Determine the status of the hard drive from the hot-plug hard drive LEDs
3.
LEDs" on page 19).
Resume normal server operations.
Removing a hot-plug SCSI hard drive
CAUTION: Always power down the server if the boot partition resides on the drive you are replacing or if
you are replacing the only drive in the server.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
Determine the status of the hard drive from the hot-plug hard drive LEDs
1.
LEDs" on page 19).
Back up all server data on the hard drive.
2.
Remove the hard drive.
3.
("Hot-plug SCSI hard drive
("Hot-plug SCSI hard drive
Hardware options installation 49