Porsche Cayenne 2009 Owner's Manual page 307

8.Inflate the tire if necessary.
Please see the chapter "TIRE PRESSURES,
COLD" on Page 358.
On vehicles with Tire Pressure Monitoring:
Please see the chapter "SETTING THE TIRE
TYPE AND SIZE" on Page 134.
9.Lower the car and remove the jack.
10.Tighten wheel bolts in diagonally opposite
sequence.
Maintenance Note
f Immediately after changing a wheel, use
a torque wrench to check the prescribed
tightening torque of the wheel bolts
(160 Nm/118 ftlb.).
f Spacer, steel nuts, and plastic covers should
be stored together.
Fitting the 17 mm spacer
1. Remove wheel.
2. Fit the spacer with the wheel bolts A used to
fasten the wheel.
Tightening torque: 160 Nm (118 ftlb.)
3. Fit wheel.
To do this use the original wheel nuts for
fastening the wheels.
Tightening torque: 160 Nm (118 ftlb.)
Place plastic covers onto the steel nuts.
Note
There is no anti-theft protection for the wheel nuts.
Collapsible spare wheel
The collapsible spare wheel is fastened under the
floor in the luggage compartment.
On vehicles with 17 mm spacers:
f Before fitting a collapsible spare wheel on the
rear axle always remove the corresponding
spacer.
For information on the spacers:
Please see the chapter "SPACERS" on
Page 295.
For information about removing the spacers:
Please see the chapter "CHANGING A WHEEL
WITH REMOVAL OF 17 MM SPACER" on
Page 305.
1. Take out rotary knob A and put it on bolt B.
2. Unscrew the screw and take out the collapsible
spare wheel.
3. Mount the collapsible spare wheel on the vehi-
cle before inflating it. Leave the car jacked up.
Please see the chapter "LIFTING THE VEHICLE
WITH A JACK" on Page 301.
4. Inflate the tire.
Please see the chapter "TIRE PRESSURES,
COLD" on Page 358.
Minor Repairs
307