Table of Contents
Advertisement
2.1 Hardware Installation Procedures
Before start using NAS-5400, please follow the procedures below to complete the hardware
Installation.
Step 1: Install at least one hard disk via hot-swappable drive tray and insert the tray to one of
the drive bays of NAS-5400. Note that All HDDs must be set to master mode.
Step 2: Connect one end of an Ethernet cable to the LAN port located on the NAS-5400 rear
panel and attach the other end to a hub or switch.
Step 3: Connect the provided power cord to the power supply of the NAS-5400. Press the A/C
switch of the power supply to ON position.
Step 4: The red system LED is continuously on for 2 seconds, then the green system LED flash
rapidly (one flash per 0.5 second) indicating the NAS-5400 is booting.
Step 5: The continuous green LED indicates the NAS-5400 is ready to use.
Note: NAS-5400 has two power supplies by default. If you only deploy electricity to one power
supply, the Power Fail Buzzer would keep beeping for warning. You can turn it off by
pressing the red button (Power Fail Buzzer Reset Button), which locates at the right side of
the rear panel.
2.2 Installing Hard Drives to HDD Trays
The NAS-5400 has four hot-swappable HDD trays, which can be used to install 3.5" IDE hard
drive each. You don't' need to turn off the server when replacing a failed hard drive. The hard drive
must be 3.5" ATA66/100/133 IDE compliance. The hot-swappable drive tray connects to the
backplane. The backplane is the printed circuit board behind the bay.
Note:
1.
Do not use any other drive tray which is not designed for NAS-5400, or a serious damage
might be caused.
2.
For best flexibility, the NAS-5400 is designed to fit most types of hard drive form various
hard disk drive vendors. But each of them might have slightly different mechanical
dimension. We strongly recommend applying hard drives with the same type or with the
same dimension to NAS-5400.
Chapter 2
Installation
5
Advertisement
Table of Contents
