Positioning The Microphone And Speakers; Attaching And Removing The Headset; Using The Flip-Up Antenna - Cardo Systems scala rider G4 User Manual

7. The adhesive pad bonds to full strength over the next 24
hours. Therefore it is recommended to not use the headset
during this 24 hour period.
8. Fasten the Clamp to the Glue Plate using the Allen screws
that were previously removed.

5.2 POSITIONING THE MICROPHONE AND SPEAKERS

The microphone must be positioned in
front of the center of your mouth as
detailed above.
Attach the speakers to the Velcro
inside your helmet, opposite your
ears (short speaker cord for left ear &
long speaker cord for right ear). Use
the supplied Velcro pads if needed.
Using two speakers inside the
helmet may be prohibited in
certain jurisdictions. If this is the
case, you should tuck away the
long corded speaker under-
neath the helmet padding as
follows:
Lead the speaker cord [B]
alongside the rim of the
padding to the right side
and then back to the left
side, near speaker [A]. Then
place the speaker [B]
underneath the padding.
8 scala rider ® G4 Instructor Kit
™
Speaker A
Speaker B
Cable
Speaker B
Speaker B
Speaker A
NOTE: For best audio results, make sure that both of your speakers
actually touch your ears.
Please visit us at www.cardosystems.com/faq and look for some
very useful tips under the Audiokit category.

5.3 ATTACHING AND REMOVING THE HEADSET

ATTACHING:
Slide the headset sideways (i.e. horizon-
tally) along the sliding panel until a click-
ing sound indicates that the headset is
locked in place.
REMOVING:
Your headset can be removed for charg-
ing or for storage by sliding the headset
sideways.

5.4 USING THE FLIP-UP ANTENNA

The flip-up antenna allows you to achieve the maximum inter-
com range between trainees and
instructor. To open the antenna,
press gently against the protrud-
ing tab (at the tip of the antenna)
towards the direction of the hel-
met. The internal spring will then
cause the antenna to flip up. To close the antenna, just push it
back into its horizontal state until it is locked in place.
slide headset sideways
push headset with your thumb