Cisco 6921 Administration Manual page 63

Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Table 4-1 Network Setup Menu Options (continued)
Option
PC VLAN
SW Port Configuration
PC Port Configuration
Cisco Unified IP Phone 6921, 6941, and 6961 Administration Guide for Cisco Unified Communications Manager 7.1 (SCCP)
OL-19025-01
Description
Allows the phone to interoperate with 3rd party switches
that do not support a voice VLAN. The Admin VLAN ID
option must be set before you can change this option.
Speed and duplex of the network port. Valid values:
• Auto Negotiate
100 Half—100-BaseT/half duplex
•
100 Full—100-BaseT/full duplex
•
10 Half—10-BaseT/half duplex
•
10 Full—10-BaseT/full duplex
•
If the phone is connected to a switch, configure the port
on the switch to the same speed/duplex as the phone, or
configure both to auto-negotiate.
If you change the setting of this option, you must change
the PC Port Configuration option to the same setting.
Speed and duplex of the access port. Valid values:
Auto Negotiate
•
100 Half—100-BaseT/half duplex
•
100 Full—100-BaseT/full duplex
•
10 Half—10-BaseT/half duplex
•
10 Full—10-BaseT/full duplex
•
If the phone is connected to a switch, configure the port
on the switch to the same speed/duplex as the phone, or
configure both to auto-negotiate.
If you change the setting of this option, you must change
the SW Port Configuration option to the same setting.
Network Setup Menu
To Change
Make sure the Admin VLAN ID
1.
option is set.
Scroll to the PC VLAN option,
2.
press the Edit softkey, and then
enter a new PC VLAN setting.
3. Press the Apply softkey, then
press Save.
1. Unlock network configuration
options.
2. Scroll to the SW Port
Configuration option and then
press the Edit softkey.
3. Scroll to the setting that you
want and then press the Select
button.
Unlock network configuration
1.
options.
Scroll to the PC Port
2.
Configuration option and then
press the Edit softkey.
3. Scroll to the setting that you
want and then press the Select
button.
4-5