Page 1
SPA-SIDE REMOTE CONTROL FOR USE WITH PENTAIR CONTROL SYSTEMS INSTALLATION AND USER’S GUIDE IMPORTANT SAFET Y INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS iS4 Spa Side Remote Installation and User’s Guide...
CUSTOMER SERVICE / TECHNICAL SUPPORT If you have questions about ordering Pentair Aquatic Systems replacement parts, and pool products, please use the following contact information: Customer Service Technical Support (8 AM to 4:30 PM Sanford, North Carolina Eastern and Pacific Times (8 A.M.
Failure to do so could result in death or serious injury to service professional, pool users or others due to electrical shock. READ AND FOLLOW ALL INSTRUCTIONS IN THIS MANUAL SAVE THESE INSTRUCTIONS iS4 Spa Side Remote Installation and User’s Guide...
(such as lights, jet pump, air blower, etc.). One iS4 spa-side control can be installed per control system. It is possible to install two iS4 remotes on a single control system, however, the two iS4 remotes will mirror each other in functionality.
½ in. or ¾ in., and run to the Control Power/Load Center. 3. Use sweep elbows for turns. NOTE: For new gunite spa installations, the iS4 Mounting Adapter has no purpose and can be discarded. iS4 Spa-Side Remote 1 in.
4. Bond iS4 Mounting Adapter provided over Spa Wall Mounting Adapter using silicon. 5. Run spa-side remote cable through conduit to control power/load center. Affix remote to iS4 Mounting Adapter using small amount of silicon on back of unit. Attach appropriate labels (P/N 522082) to the remote.
Load Center. See Figure 5. 4. Use the color call-out description on back of remote to wire unit. 5. Affix remote to iS4 Mounting Adapter using small amount of silicon on back of unit. 6. Attach appropriate labels to remote.