Advertisement
USING 3D GLASSES
Power On
Power Off
Auto Off
*1
Battery discharge
Re-syncing the Glasses
*1
The Auto Off function automatically turns the power off when there is no signal between the TV and glasses for more than one
minute. You cannot watch 3D images when the Auto Off function automatically turns the power off. This can happen when the
distance or angle between the TV and glasses is out of range; when there is a barrier between the TV and glasses; or when the TV
is switched from 3D to 2D mode.
!
NOTE
Make sure to turn off the 3D glasses when they are not in use. Otherwise, the battery life shortens.
▶
ASSEMBLING THE GLASSES
The temple arms of the glasses are provided in the package. Attach them to the frame according to the in-
structions below.
1
!
NOTE
Make sure that the left and right arms are attached to the corresponding side of the frame.
▶
REPLACING THE BATTERY
The coin cell battery is not rechargeable. Please replace it when the red LED indicator flashes continuously.
1
Locate the battery cover.
Make sure that the battery is inserted correctly with the plus sign facing towards the same sign marked
▶
!
NOTE
on the cover.
Risk of explosion if battery is replaced by an incorrect type.
▶
CAUTION
dispose of used batteries according to the instruction.
▶
ATTACHING THE NOSE PAD
Using 3D glasses may not be comfortable for users wearing regular eyeglasses. Adjusting the nose pad can
improve your viewing comfort.
1
!
NOTE
Follow the instructions in reverse order to reattach the nose pad.
▶
The nose pad can be adjusted even if you are not wearing glasses.
▶
Button Operation
Press and hold the power button for one to two
seconds.
Press and hold the power button for one to two
seconds until the LED indicator turns red.
The product is automatically turned off if there
is no 3D signal for more than one minute.
-
Press the power button for at least eight sec-
onds.
2
Press the cover slightly,
then lift it up.
2
The red LED indicator flashes once.
The red LED indicator flashes three times.
The red LED flashes three times.
The red LED flashes for one minute and
turns off automatically.
When the LED indicator turns green, release
the power button. The green LED indicator
flashes three times and turns off. If you turn
the power on again, the 3D glasses detect
the TV with the strongest signal.
Insert each arm into the frame in the direction shown in the
figure until it clicks.
3
Pull the cover open.
- Pull the nose pad in the direction shown by the arrow in the
image. Be careful not to twist or lift the nose pad, as this can
cause damage.
- Remove the nose pad when the battery cover is fully closed.
LED Indicator
4
Place the battery onto the
cover, then close the cover.
3
Advertisement
