Operation - Grizzly G6772 Instruction Manual

Loading Stapler
To load your stapler:
1. Disconnect the air supply from the
stapler!
2. Pull the magazine pusher (shown in
Figure 1) all the way to the back of
the magazine until is snaps in place.
Figure 1. Pull magazine pusher back.
3. Point the stapler down and insert a
stick of staples onto the magazine as
shown in Figure 2. Make sure that the
pointed ends of the staples point in
the same direction as the stapler nose
piece.
Figure 2. Loading staples onto stapler.
-6
-

OPERATION

4. Release the plunger on the pusher
while holding the pusher, so it does
not spring forward out of control.
5. Carefully let the pusher come for-
ward until it stops.
When replacing staples for your Model
G6044/G6772, follow these guidelines:
Gauge: 16
5
Length: ⁄ "-2"
8
7
Width: ⁄ "
16
Capacity: 140 Staples
Single/Bump Fire Mode
The Model G6044/G6772 is equipped with
a single/bump fire trigger.
To select single or bump fire operation:
1. Disconnect the air supply from the
stapler!
2.
Locate the hex nut that secures the
safety yoke mechanism to the trigger
housing. See Figure 3.
3. To select Single Fire mode, tighten
the hex nut completely.
4. To select Bump Fire mode, unthread
the hex nut at least two full turns.
Figure 3. Loading staples into stapler.
G6044/G6772 16 Gauge Stapler Kit
Adjustment
Hex Nut