Emergency Emptying Out; Frost Precautions - AEG LAVAMAT 61270 WDBI User Manual

26 www.aeg.com
To clean the water inlet filters:
20°

EMERGENCY EMPTYING OUT

If the water is not discharged, proceed as
follows to empty out the appliance:
1. pull out the plug from the power
socket;
2.
close the water tap;
3. if necessary, wait until the water has
cooled down;
4. place a bowl on the floor;
5. place the end of the emergency emp-
tying hose into the bowl;
6. Remove its cap. The water should
drain by gravity into the bowl. When
the bowl is full, put the cap back on
the hose. Empty the bowl;
Repeat the procedure until water
stops flowing out;
7. clean the pump if necessary as previ-
ously described;
8. replace the emergency emptying
hose in its seat after having plugged
it;
9. screw the pump again.
45°
1. Close the water tap.
2. Remove the water inlet hose from the
water tap.
3. Clean the filter in the inlet hose with a
stiff brush.
4. Remove the inlet hose behind the
appliance.
5. Clean the filter in the valve with a stiff
brush or a towel.
6. Install again the inlet hose. Make sure
that the couplings are tight to pre-
vent leakages.
7. Open the water tap.

FROST PRECAUTIONS

If the machine is installed in a place where
the temperature could drop below 0°C,
proceed as follows:
1. close the water tap;
2.
unscrew the water inlet hose from the
tap;
3. place the end of the emergency emp-
tying hose and that of the inlet hose
in a bowl placed on the floor. Let wa-
ter drain out;
4. screw the water inlet hose back on;
5. put the cap on the emergency empty-
ing hose again;
6. reposition the emergency emptying
hose.
By doing this, any water remaining in the
machine is removed, avoiding ice forming
and consequently damage to the appli-
ance.
When you use the machine again, make
sure that the ambient temperature is
above 0°C.