Wheel Alignment - Grizzly G0621X Owner's Manual

3.
4.
5.
Note: Shim stock works well for this, but small
pieces of paper can also work in a pinch.
To compensate for lead when making straight
crosscuts with the miter gauge, you will need
to shift the table:
1.
2.
3.
4.
5. Steps 1 & 2
NOTICE
If the table is shifted, the fence will be
affected since it is attached.
NOTICE
Lead adjustments will change when new
blades are mounted on the saw.

Wheel Alignment

Verifying Upper/Lower Wheels are
Coplanar
1.
2.
Figure 49
Figure 49.