N.cg Tilt Power Accessory; Transit Use; Set Up, Adjustment & Use; Notes - Sunrise Medical Quickie X2 Owner's Manual

N.CG TILT POWER ACCESSORY

WARNING
The powered CG Tilt accessory for this chair has a maxi-
mum user weight capacity of up to 400 lbs. Never exceed
this capacity while operating the powered actuator.
WARNING
O. TRANSIT USE
Your chair has been manufactured with built-in Transport Brackets
on.
WARNING
These transport brackets have not been crash-tested in accor-
dance with WC-19. Use these transport brackets only to secure
an unoccupied wheelchair during transport
1. NEVER let anyone sit in this chair while in a
moving vehicle.
2. NEVER transport this chair in the front seat
of a vehicle. It may shift and interfere with the
driver
3. ALWAYS secure this chair so that it cannot
roll or shift.
4. Do not use any chair that has been involved in
a motor vehicle accident.
Quickie X2 Owner's Manual
VIII, SET UP, ADJUSTMENT AND USE

NOTES

1.Work Surface For Set-Up:
Use a flat surface, such as a table, to assemble, adjust and check your
chair. This makes the steps easier and helps ensure a correct set-up.
2. Fasteners:
• Many of the screws and bolts on this chair are special high-
strength fasteners and may have special coatings.
• Many nuts are of the Nylock type. They have a plastic insert
to help prevent loosening.
• Only use screws, bolts and nuts provided by Sunrise.
1. Use of improper fasteners may cause the chair to fail.
2. Over- or under-tightened fasteners may fail or cause
damage to chair parts.
3. If bolts or screws become loose, tighten them as soon
as you can. Loose bolts or screws can cause damage to
other chair parts causing them to fail.
3. Washers & Spacers:
• Note the position of washers and spacers before disassembly.
• To avoid damage to the frame, replace all washers and spacers
when you reassemble parts.

TOOLS YOU WILL NEED

1. Basic Tool Kit:
To set-up, adjust and maintain your chair you may
need the following tools:
• Combined Phillips and flat screw driver
• Standard metric wrenches from 10mm
• Metric Allen wrenches from 5mm
• Imperial wrenches from 1/4" to 9/16"
• Imperial Allen wrenches from 5/64" to 1/4"
You can obtain a multi-purpose tool kit from Sunrise, or
buy the tools you need from a hardware store.
2. Torque Wrench:
If you plan to adjust and maintain this chair yourself,
Quickie recommends that you use a torque wrench.
Q-NOTE- The wrench must measure inch-pounds (N.m). You can
buy a torque wrench and proper sockets from a hardware store.
Rev. A
WARNING
13.