Air Regulator/Filter - Grizzly G0644 Owner's Manual

To lubricate the elevation gears:
1. DISCONNECT THE
POWER!
2.
Use a 4mm hex wrench to loosen the set
screw in the elevation handwheel hub, then
remove the handwheel to access the eleva-
tion gears, as shown in Figure 30.
Figure 30. Elevation gears (elevation handwheel
removed).
3. Apply a small amount of multi-purpose grease
on the gears.
4.
Reinstall the handwheel, then move the
sanding cabinet through its entire range of
movement to evenly distribute the lubricant.
-28-
SANDER FROM

Air Regulator/Filter

The air regulator filters the incoming compressed
air and deposits the collected water in the filter
reservoir (see Figure 31).
Filter Reservoir
Figure 31. Air regulator filter reservoir and drain
valve.
To empty the filter reservoir, make sure there is
incoming air pressure and press the drain valve
up. This will release a flow of air and the collected
water.
G0644 15" Open-End Wide Belt Sander
Drain Valve