Table of Contents
Advertisement
Additional Warnings (continued)
Electric Motor Safety
●
Keep the electric motor free of dirt and debris, especially in the throttle
linkage area.
●
Never start the electric motor without checking to see that the throttle
control is in the idle position.
●
Never start the electric motor unless you are properly seated with your
hands firmly on the controls.
●
All guards must be in place prior to starting the electric motor.
●
Operating the vehicle in conditions where water, mud, snow, dirt,
sand or other debris can get into the throttle cable conduit and/or the
throttle mechanism can cause the cable or throttle mechanism to bind,
which may lead to throttle sticking, loss of control, and possible death,
injury, and/or property damage.
Fasteners
●
Make sure that all screws, nuts, and bolts are properly tightened. Never
over-tighten hardware that is designed to move, such as front wheels,
spindles, A-arm pivots, etc. Restricting moving parts can cause a loss
of control and possible injury or death.
●
Always replace torque-type locknuts with new locknuts of the same
type after removing the old locknuts.
Charging
●
Make sure master power switch located under the seat is turned on.
●
Plug charger into outlet below seat cushion. A light will illuminate on the
charger to show that battery is being charged. When the battery has a
full charge a green light will illuminate. Charging time usually last 3-12
hours, however the initial charge should be 12-24 hours.
●
Battery should be charged as soon as a lack of power is shown. Battery
should be charged at least once a month when unit is not being used
for a long period of time.
6
Hide quick links:
Advertisement
Table of Contents
