Gigabyte GA-M85M-US2H User Manual page 78

B. Installing Windows Vista
(The procedure below assumes that only one RAID array exists in your system.)
Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation
steps. When a screen similar to that below appears (RAID hard drive will not be detected at this stage),
select Load Driver. (Figure 3).
Step 2:
Specify the location where the driver is saved. For users using a SATA optical drive, be sure to copy
the driver files from the motherboard driver disk to a USB flash drive before installing Windows Vista (go
to the BootDrv folder and save the whole Vista32RAID or Vista64RAID folder to the USB flash drive).
Then use Method B to load the driver.
Method A:
Insert the motherboard driver disk into your system and browse to the following directory:
\BootDrv\Vista32RAID
For Windows Vista 64-bit, browse to the Vista64RAID folder (Figure 4).
Method B:
Insert the USB flash drive containing the driver files and browse to the Vista32RAID (for Windows Vista
32-bit) or Vista64RAID (for Windows Vista 64-bit) folder.
GA-M85M-US2H Motherboard
Figure 3
Figure 4
- 78 -