Kia Rondo 2014 Owner's Manual page 369

Driving your vehicle
This section contains many time-
tested, important trailering tips and
safety rules. Many of these are
important for your safety and that of
your passengers. Please read this
section carefully before you pull a
trailer.
Load-pulling components such as
the engine, transaxle, wheel assem-
blies, and tires are forced to work
harder against the load of the added
weight. The engine is required to
operate at relatively higher speeds
and under greater loads. This addi-
tional burden generates extra heat.
The trailer also adds considerably to
wind resistance, increasing the
pulling requirements.
5 62
✽ ✽ NOTICE
- Location of trailer
mounting
• The mounting hole for hitches are
located on both sides of the under-
cover behind the rear tires.
• Remove the under cover on the
rear bumper before installing a
trailer hitch.
Hitches
It's important to have the correct
hitch equipment. Crosswinds, large
trucks going by, and rough roads are
a few reasons why you'll need the
right hitch. Here are some rules to
follow:
• Will you have to make any holes in
the body of your vehicle when you
install a trailer hitch? If you do, then
ORP052051
be sure to seal the holes later
when you remove the hitch.
If you don't seal them, deadly car-
bon monoxide (CO) from your
exhaust can get into your vehicle,
as well as dirt and water.
• The bumpers on your vehicle are
not intended for hitches. Do not
attach rental hitches or other
bumper-type hitches to them. Use
ORP052058
only a frame-mounted hitch that
does not attach to the bumper.
• Kia trailer hitch accessory is avail-
able at an authorized Kia dealer.