Positioning The Unit; Operating The Unit; When Using The Unit - Heat Controller R-410A Owner's Manual

Owner's Manual

Positioning the Unit

Positioning the unit
A
A dehumidifier operating in a basement will have little or no effect in drying an adjacent enclosed
storage area, such as a closet, unless there is adequate circulation of air in and out of the area.
Do not use outdoors.
This dehumidifer is intended for indoor residential
applications only. This dehumidifier should not be used
for commercial or industrial applications.
Place the dehumidifier on a smooth, level floor strong
enough to support the unit with a full bucket of water.
Allow at least 8in. (20cm) of air space on all sides of the unit
Allow at least 20cm of air space on all sides of the unit
for good air circulation.
Place the unit in an area where the temperature will not
41°F (5°C).
fall below 5 C(41 F). The coils can become covered with
frost at temperatures below 5 C(41 F), which may reduce
performance.
performance.
Keep unit away from heat sources, such as clothes dryer,
Place the unit away from the clothes dryer, heater or radiator.
heater or radiator.
Use the unit to prevent moisture damage anywhere books
Use the unit to prevent moisture damage anywhere books or
or valuables are stored.
valuables are stored.
Use the dehumidifier in a basement to help prevent moisture
Use the dehumidifier in a basement to help prevent
damage. NOTE: A dehumidifier operating in a basement will
moisture damage.
have little or no effect in drying and adjacent enclosed storage
The dehumidifier must be operated in an enclosed
area, such as a closet, unless there is adequate circulation of
area to be most effective.
air in and out of those additional areas.
Close all doors, windows and other outside openings
The dehumidifier must be operated in an enclosed area to be
most effective.
to the room.
Close all doors, windows and other outside openings to the
room.

When using the unit

NOTE: When removing the dehumidifier from its
When Using The Unit
packaging, you will find plastic adhesive tape pasted
on several places of the unit (see Fig.4b). It is for
When removing the dehumidifier from its
NOTE:
transportation purpose only, just remove them before
packaging, you will find tape pasted on several
you using the dehumidifier.
places of the unit (see Fig. 4b). It is for transpor-
tation purposes only, just remove tape before
When first using the dehumidifier, operate the unit
using the unit.
continuously 24 hours.
This unit is designed to operate with a working
environment between 5 C and 35 C.
If the unit has been switched off and needs to be
switched on again quickly, allow approximately
three minutes for the correct operation to resume.
Do not connect the dehumidifier to a multiple socket
outlet, which is also being used for other electrical
appliances.
Select a suitable location, making sure you have easy
access to an electrical outlet.
Plug the unit into a electrical socket-outlet with earth
connection.
appliances.
Make sure the Water bucket is correctly fitted otherwise
the unit will not operate properly.
connection.
BHD-G Portable Dehumidifier
.
41°F (5°C)
O O
14 F and 95 F (5 C - 35 C).
O O O
installed otherwise
.
.
Air intake
Air intake
grille
grille
8in. (20cm) or more
20cm or more
20cm or more
Casters(At four points on the bottom of unit)
Casters can move freely.
Do not force casters to move over carpet,
nor move the unit with water in the bucket.
(The unit may tip over and spill water.)
Accessing drain hose, fitting and (2) screws are
located inside the bucket. On some models, the
drain fitting is placed inside the Styrofoam base
packaging of the unit.
Locate and remove these items before operating
the unit or dispose of packing materials.
O
a ground
7
7
O P E R A T I N G T H E U N I T

OPERATING THE UNIT

40cm or
16in.
(40cm)
more
or more
Air outlet grille
Air outlet grille
20cm or more
80cm or more 8in.
8in. (20cm) or more
(20cm) or more
20cm or more
Fig.4a
Fig.4a
.
Adhesive tape
Fig.4b
Adhesiv
Fig.4b
Heat Controller, Inc.
8in. (20cm) or more
.)
ape