System Passcode - Maxent 42" Owner's Manual

System Passcode

Setting System Passcode
The system passcode setting is used in conjunction with V-Chip (Parental Guide) and Channel Lock functions.
The same security passcode is used for both functionality. By default, this TV is programmed with the security
passcode set at 0000.
Press to access the OSD menu. Use
keys to select SETUP then press
enter SETUP menu.
Use to select the PASSCODE option
then press to enter PASSCODE menu.
A small display window appears prompting the
user to enter the existing passcode. Use the
number keys on the remote control to input the
code. If the code has not been set before,
please use the default "0000" code.
As each numeric digit is entered, a small "X"
fills each slot. If the code entered is incorrect,
an "Error" status is displayed. Simply re-enter
the passcode again.
Notes:
When entering the 4-digit passcode, please
enter the digits slowly. The TV will display
"X" in each of the number slots as it
receives the passcode.
If the wrong passcode is entered three
times, the TV will go back to the SETUP
menu. Repeat the above procedure to
reset your passode.
After the original passcode is entered correctly,
the TV will now prompt the entering of a new
passcode. Enter a four digit passcode using
the numeric keypad on the remote control.
Advanced Functions
or to
PASS CODE ENTER
ENTER CODE
ENTER NEW CODE
ENTER CODE
Error Condition
PASS CODE ENTER
ENTER CODE
PASS CODE ENTER
ENTER CODE
EXIT
EXIT
X
EXIT
EXIT
EXIT
EXIT
EXIT
EXIT
EN
47
PASSCODE
47