Temperature Adjustment; Fan Mode Selection - ClimateMaster ATC32U01 iGate User Manual

AT C 3 2 U 0 1 C o m m u n i c a t i n g , P r o g r a m m a b l e T h e r m o s t a t - U s e r M a n u a l
R e v. : 2 J u l y, 2 0 1 2

2.0 Temperature Adjustment

To adjust the temperature on the thermostat, use the left/
right arrow buttons to select the TEMP user option on the
Home Screen and then press the center button or press the
up or down arrow key. The Temperature Adjustment Display
appears and shows either one (in Heat, Cool, or Emergency
Heat modes) or both (in Auto mode) temperature setpoints.
Adjust the setpoints using the up/down arrow buttons.
Navigate between setpoints using the left/right arrow buttons.
Press the center button to save changes.
• Heat Setpoint (default 60°F): options: 55°F to
Maximum Heating Setpoint Limit (section 5.6.8)
• Cool Setpoint (default 80°F): options: Minimum
Cooling Setpoint Limit (section 5.6.8) to 95°F
NOTE 1: The thermostat must be in any mode other than
OFF (section 2) to adjust temperature setpoint(s).
NOTE 2: The thermostat forces a 2°F "dead-band" between
the Heating and Cooling setpoints. While adjusting
the Heating setpoint, the Cooling setpoint may be
automatically increased to enforce a 2°F "dead-
band". Likewise, while adjusting the Cooling
setpoint, the Heating setpoint may be automatically
reduced to enforce a 2°F "dead-band".
NOTE 3: In programmable mode, the TEMP option provides
the ability to temporarily modify setpoint(s) until
the start time of the next program schedule event.
While in non-programmable mode, the TEMP
option provides the ability to modify the setpoint(s).

3.0 Fan Mode Selection

To adjust the Fan Mode on your thermostat, use the left/
right arrow buttons to select the FAN user option from the
Home Screen and then press the center button. The Fan
Menu shows up to 3 possible Fan Operating Modes with the
currently active Fan Operating Mode highlighted. Use the
up/down arrow buttons to select the desired Fan Mode and
press the center button to save your selection. You may
choose from the following Fan Modes:
• Auto (default): Fan only runs with a call for
heating/cooling
• Continuous On: Fan runs continuously with or
without a call for heating/cooling
• Programmed Fan (in Programmable Mode): Fan
runs per Program Schedule settings (reference
section 5.3).
4
G e o t h e r m a l H e a t P u m p S y s t e m s
10/13/11 8:25 AM
FAN AUTO
HUMID ON
RH 41%
°
68
AUTO
SETPOINT
HEAT 62
COOL 82
RH TEMP MODE FAN MENU
HOLD THIS
TEMPERATURE
UNTIL 5:00 PM
HEAT COOL
°
70
°
74
SET TEMP
CHANGE
SAVE
PREVIOUS
10/13/11 8:27 AM
FAN AUTO
RH 40%
°
69
OFF
FAN MENU
RH TEMP MODE
FAN MENU
AUTO
CONTINUOUS ON
PROGRAMMED FAN
HEAT
SELECT OPTION
SAVE
PREVIOUS