Stand Assembly - Grizzly G0477 Owner's Manual

Stand Assembly

The stand for the Model G0477 must be assem-
bled before the planer/moulder can be mounted
on it. It may be helpful to refer to the Stand
Breakdown on Page 35 during this procedure.
Components and Hardware Needed:
Notched Legs* ................................................... 2
Plain Legs .......................................................... 2
Long Frame Pieces ........................................... 2
Short Frame Pieces ........................................... 2
Long Braces ...................................................... 2
Short Braces ...................................................... 2
Carriage Bolts ⁄ -18 x
5
16
Flange Nuts ⁄ -18 ........................................... 24
5
16
* These stand legs each have a small, semicircu-
lar notch towards to top of the leg, as shown in
Figure 5.
Figure 5. Leg notches.
To assemble the stand:
1.
Place a plain leg and a notched leg side-by-
side on the ground, with the double bolt holes
of the legs towards the top. The notched leg
should be on the right of the unmarked leg.
2.
Fasten a short frame piece to the legs using
⁄ -18 x ⁄ " carriage bolts and flange nuts.
5 3
16 4
3.
Fasten a short brace piece to the legs, using
carriage bolts and flange nuts.
Model G0477 15" Planer/Moulder
Qty
⁄ " ............................... 24
3
4
Leg Notch
4. Repeat Steps 1–3 for the other side of the
stand. The finished halves of the stand
should look like those shown in Figure 6.
Plain Legs
Short Brace Piece
Figure 6. Stand halves.
5. Fasten the stand halves together using a long
frame piece, a long brace piece, carriage
bolts and flange nuts as shown in Figure 7.
Long Frame Piece
Figure 7. Joining stand halves.
6.
Fasten the remaining long frame piece and
long brace piece to the stand using carriage
bolts and hex nuts.
Short Frame Piece
Notched Legs
Long Brace Piece
-13-