Advertisement
CONNECTING...
Before making any connection, make sure your audio source is powered off as
severe damage to equipment and/or your ears could result if audio source is left on.
To connect your headphones, plug the 1/8-inch (3.5mm) straight connector into
one of the inputs located at the base of the left (L) or right (R) ear cup, allowing
the user to pick a preferred side for a more comfortable listening setup as shown
in
Figure 2
.
1/4-inch Adaptor
If your audio equipment uses a 1/4-inch (6.3mm) output jack, use the included
1/4-inch adaptor.
Power Switch Controls on the Active M4U Headphones
Position A: Passive Mode (Figure 3a)
In Passive mode, noise cancelling is turned off. The headphones are powered by your audio
source. No power required.
Figure 3a
Position B: Active Mode (Figure 3b)
In Active mode, the internal headphone amplifier is active. The 3-position Power Switch will be
RED
"
Figure 3b
Position C: Active Noise Cancelling Mode (Figure 3c)
In Active Noise Cancelling mode, you have activated the "Noise Cancelling" feature, and the
internal headphone amplifier. The 3-Position Power Switch will be "
AAA batteries to be installed in the headphones.
Figure 3c
Low Battery Power Indicator
If in Position B or C (active), the 3-Position Power Switch will be "
will soon need to replace the batteries.
". It requires two AAA batteries to be installed in the headphones.
Figure 2
AMBER
" if your battery power is low, therefore you
3
GREEN .
" It requires two
Advertisement
