Table of Contents
Advertisement
Oiling Nailer
Special oil has been included with your
new Grizzly nailer to help maintain its use-
ful life. Place one drop of oil in the nailer air
inlet (as shown in Figure 1) before every
use. Wipe off any excess oil near the nail-
er exhaust to avoid dust build-up. When
the oil that was included with the nailer has
been completely used, replace with Grizzly
Model G2820 Pneumatic Tool Oil.
Another option to manual oiling would be
to install a lubricator in your air compressor
line. If your air compressor line already has
a lubricator, then regular lubrication of your
nailer will not be necessary. Just make
sure there is always oil in the lubricator.
As mentioned before, the best option is to
install a filter/lubricator/regulator unit such
as the Grizzly Model H4196 in your air line.
Figure 1. Lubricating nailer via air inlet.
-6
-
OPERATION
Loading Nailer
When replacing nails in your Model
H5570, follow these guidelines:
Gauge:
18
3
Length:
⁄
"-2"
4
Capacity: 100
To load your nailer:
1.
Disconnect the air supply from the
nailer!
Slide back the magazine pusher until
2.
it stops as shown in Figure 2.
Figure 2. Releasing magazine pusher.
Load a nail stick in the T-slot at the top
3.
of the magazine as shown in Figure 3.
4.
Release the magazine pusher by
pulling it back, depressing the release
button, and sliding it forward.
Figure 3. Loading finish nails into nailer.
H5570 18 Gauge Finish Angle Nailer
Advertisement
Table of Contents
