Rear Wheel - Yamaha Star XV250ZC Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
7. While applying the front brake,
push down hard on the handlebars
several times to check if the front
fork compresses and rebounds
smoothly.
8. Connect the speedometer cable.
7

Rear wheel

To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Remove the axle nut cotter pin.
2. Loosen the chain puller locknut
and the drive chain slack adjusting
nut on both ends of the swingarm.
1. Axle nut
2. Axle nut cotter pin
3. Chain puller locknut
4. Drive chain slack adjusting nut
5. Alignment marks
7-37
EAU25080 3. Loosen the axle nut and the brake
torque rod nut at the brake shoe
plate.
EAU32751
4. Lift the rear wheel off the ground
according to the procedure on
EWA10821
page 7-35.
5. Remove the brake pedal free play
adjusting nut, and then disconnect
the brake rod at the brake cam-
shaft lever.
6. Disconnect the brake torque rod
from the brake shoe plate by re-
moving the nut and the bolt.
1. Brake torque rod
2. Brake torque rod bolt and nut
3. Brake rod
4. Brake pedal free play adjusting nut
5. Brake camshaft lever