Display Messages; Handset Sound Signals - RCA 25212 User Manual

Display Messages

Display Messages
The following messages show the status of the phone, provides Caller ID
information, or helps you set up and use your phone.
DELETE ALL?
DELETE?
ENTER NAME
ENTER NUMBER
NEW CALLS
HANDSET NAME
UNAVAILABLE
NO LINE
LINE IN USE
EMPTY
OUT OF RANGE
BLOCKED
UNKNOWN

Handset Sound Signals

Signal
A long warbling tone (with ringer on)
Two short beeps (several times)
One beep every 14 seconds
One long beep after press one key
A short warbling tone (with ringer on)
36
Prompt asking if you want to erase all records.
Prompt asking if you want to erase the current record.
Prompt telling you to enter a name.
Prompt telling you to enter a telephone number.
Indicates call or calls which have not been reviewed.
Prompt telling you to enter a user name for the hand
set.
Indicates that the function you want to initialize
cannot work at that moment or the function being
worked cannot continue. The system is busy or some
other higher priority function is being performed.
For example, the message playback function will be
stopped when there is an incoming call.
Indicates that the telephone line is not connected.
Display on handset while the line is in use.
Indicates there are no CID records in memory.
Indicates handset is too far away from the base, and
the handset is searching for the base.
Indicates the person is calling from a number which is
blocked from transmission.
Indicates incoming call is from an area not serviced by
CID or the CID information was not sent.
Meaning
Signals an incoming call
Page signal
Low battery warning
Confirm
Error