Operation - Viva 7LIECH-SC-SSF User Manual

OPERATION

This unit is intended for water dispensing only. Do NOT use other liquids.
Do NOT use for other purposes. Warranty is void if used for any other
liquids including coffee, tea, juices, beer or wine.
This dispenser has been designed to use water bottles with 3 & 5 gallon
capacity. Do NOT use alternative bottles.
Initial Set Up
Notice: To prevent damage to compressor, allow unit to sit upright for at least 4 hours
prior to operating.
1.
Remove tamper seal from bottle cap. Do NOT remove plastic cap.
2.
Clean bottle cap and neck with a soft cloth and warm soapy water, then rinse.
3.
Lift bottle and insert onto the probe. Apply slight pressure until the plug inside the
cap pushes in and the bottle is seated. Water will begin to flow into the reservoirs
causing air bubbles to form in the bottle.
4.
Plug cord into a properly grounded wall outlet.
5.
Turn energy saving switch on back of dispenser to ON. This switch controls the
heating of water. If you do not want hot water, turn this switch OFF.
Initial Rinsing of Water Lines
This unit has been tested and sanitized prior to packing and shipping. During transit dust
and odors can accumulate in the tank and lines. You must dispense and dispose at least
one quart of water prior to drinking any water.
Dispense Cold Water
Note: After setup, it will take 1 hour to get water to maximum cold temperature. During
this time the compressor will run continuously. This is normal.
1. Position bottle, glass, pitcher or cooking pot securely below cold water tap.
- The circular shapes in the drip plate help align the flow of water. This unit
dispenses water at a fast rate. To avoid splashes, hold cup as close to the tap as
possible.
2. Depress cold water control downward to start flow.
3. Release cold water control once desired fill level is achieved.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 855-VIVA-111 for assistance.
10